CUET Engineering Graphics Syllabus| Check The Major Topics And Download the PDF for free!
Candidates applying for the CUET Examination 2022 can check out the topics and units included in the syllabus of Engineering Graphics given below.
ISOMETRIC PROJECTION OF SOLIDS
Unit 1: Construction of isometric scale showing main divisions of 10mm and smaller divisions of 1mm, also showing the leading angles. Isometric projection (drawn to isometric scale) of solids such as cube; regular prisms and pyramids (triangular, square, pentagonal and hexagonal); cone; cylinder; sphere; hemisphere; keeping the base side of the solid parallel or perpendicular to HP/VP. The axis of the solid should be either perpendicular to HP / VP or parallel to HP and VP.
ISOMETRIC PROJECTION OF SOLIDS
Unit 2: Combination of any two above-mentioned solids keeping the base side parallel or perpendicular to HP/VP and placed centrally together (Axis of both the solids should not be given parallel to HP).
Machine Drawing (Machine Parts)
Unit 3: Drawing to full-size scale with instruments. Introduction of threads: Standard profiles of screw threads – Square, Knuckle, B.S.W., Metric (external and internal); Bolts – Squarehead, Hexagonal head; Nuts – Squarehead, Hexagonal head; Plain washer; a combination of nut and bolt with or without a washer for assembling two parts together.
Machine Drawing (Machine Parts)
Unit 4: Free-hand sketches Conventional representation of external and internal threads; Types of studs – Plain stud, Square-neck stud, Collar stud; Types of rivets – Snap head, Flathead, Pan head (without tapered neck), 600 Counter Sunk Flathead.
Machine Drawing (Assembly and Dis-assembly)
Unit 5:Bearings
(i) Open-Bearing
(ii) Bush-Bearing
Unit 6: Rod Joints
(i) Cotter joints for round-rods (Sleeve and cotter joint)
(ii) Cotter-joints for square rods (Gib and cotter-joint)
Unit 7: Tie-rod and Pipe-joint
(i) Turnbuckle
(ii) Flange pipe joints are to be shown.
Download the CUET Engineering Graphics Syllabus PDF here.
CUET Engineering Graphics Syllabus – FAQs
CUET is the Central Universities Entrance Test
The last date to apply for the CUET Examination is 6 May 2022.
A total of 50 questions will be asked in the paper out of which 40 must be attempted by the candidates.
The selection procedure for the CUET Examination is a written examination and an interview
A total of 7 units are there.
